Version 1.9.6
The Praim Toolkit software allows to create a USB pen drive that can be used to restore a Praim thin client.
This guide is valid for Praim thin client models.
For ThinOX thin client: only firmware 8.2.x and newest are suitable to be used with these procedures.
USB direct access requirements
In order to work properly, Praim Toolkit requires to have direct access to the USB device. In case of installation on a virtual machine, verify the USB redirection feature or similar are available.
Praim Toolkit can be installed on the following supported Operating Systems in both 32 or 64-bit architecture:
In all Praim thin client models, except Flexi models, you can use a USB pen drive generated through the Praim Toolkit.
Praim Toolkit allows to manage USB pen drive for software thin client ThinOX4PC version greater than 10.2.11.
The thin client model displayed in this case is T9050.
ThinOX4PC | rel. 10.2.11 or greater |
---|---|
T9050 |
Praim Toolkit allows to manage the following ThinOX Operating System versions installed on thin clients:
ThinOX | |
---|---|
release 8.2.x or greater |
Praim Toolkit allows to manage the following Windows Operating System versions installed on thin clients:
Windows | |
---|---|
Windows Embedded 7 | |
Windows 10 IoT |
In the table below are listed the USB pen drive that are proven not working during the restore operation either operating systems ThinOX and Windows.
Manufacturer | VID | PID | USB Capacity |
---|---|---|---|
General UDisk | ABCD | 1234 | 8 GB |
Unknown | 1234 | FFFF | many |
How-To
Check also the How-To section.
FAQ
Check also the Frequency Asked Questions section.