The ThinOX4PC - T9050 Live USB Key allows the use of ThinOX O.S. without the need to install it on a PC or other devices.
The LIVE KEY will not install anything on the device
The ThinOX4PC - T9050 Live USB Key will not install anything on the device used to run it.It is an operating system that runs on the USB Key and does not affect any storage attached to the device (including the hard disk).
After using the ThinOX4PC - T9050 Live on a device, just shut it down, remove the USB Key and power it on again. The original operating system will start.
If you need to create the ThinOX4PC Live USB Key please follow the procedure below. Once the USB Key has been created use it on a device (access the BIOS Boot Menu and select the USB key).
Once started, the system has to be licensed following this procedure: Activate and license ThinOX4PC (read accurately the documentation, if the network is configured correctly the license will be obtained automatically from the ThinMan Server).
If the ThinOX4PC - T9050 Live does not find the ThinMan Server or there is no available license, the ThinOX4PC - T9050 Live will alert the user and after 10 reboots it will reset the device to factory settings.
For more information on ThinOX configuration and use, refer to the ThinOX11 section.
ThinOX4PC - T9050: Live Version versus Installed version
The ThinOX4PC - T9050 Live version does NOT mount USB mass storage devices. Hence, the Live version cannot be used when it is needed to redirect USB mass storage to the virtual environment.
¶ System Requirements
Be sure the thin client/PC where you run the live key has at least:
- RAM: 2Gb
- Processor: 64-bit and 2Ghz.
¶ Procedure to create a ThinOX4PC Live USB Key
¶ Download the ThinOX4PC Live image file from MyPraim
From MyPraim area, download the image file of ThinOX4PC - T9050 Live.
Select Products → Download menu.
Click on the Download button corresponding to the ThinOX4PC - T9050 Live product.
The downloaded file is an auto-extract file that contains the ".img" file and the Rufus tool (see below).
Execute it on a PC to extract the two files contained in it:
- rufus-x.y.exe
- T9050_live_x.y.z.img
¶ Create the ThinOX4PC Live USB Key
Insert the USB Key (at least 16GB) where you want to write the ThinOX4PC -T9050 Live operating system (NOTE: all the content of the USB Key will be lost) and execute the Rufus tool.
-
Select in the Rufus interface the USB Key.
-
Select "DD Image" in the combo box.
-
Click on the image icon and, using the file manager, select the file containing the ThinOX4PC -T9050 Live image.
-
click on the Start button.
When the operation is finished (Rufus will notify it) close the Rufus software and eject the USB Key using the Safely Remove Hardware and Eject Media procedure on Windows PC.