Page tree

Skip to end of metadata
Go to start of metadata

Praim Toolkit ver. 1.5.6

Supported Thin Client Models

This version of Praim Toolkit supports these thin client models:

  • XT900-I, XT920-I, XT901-I

  • XT9000-I XT9200-I, XP9400-I, WE9700-I

  • XT9000-C, XT9200-C, XP9400-C, WE9700-C

  • XT9000-U, XT9200-U, XP9400-U, WE9700-U

  • XT9050-A, XP9400-A, WE9700-A

  • XT9050-TC180, XT9200-TC180

  • BT9000

  • C9010, C9050, C9200, C9400, C9700, C9080

  • A9050, A9700
  • U9050, U9200, U9700, U90-HDX, U90-RFX, U90-HOR
  • A9054, A9074, A9084, A90-HDX, A90-RFX, A90-HOR
  • U9054, U9074, U9084
  • D9054, D9074, D9084, D90-HDX, D90-RFX, D90-HOR
  • N9012, N9052, N9072, N90-HDX, N90-RFX, N90-HOR
  • N9112, N9152, N9172, N91-HDX, N91-RFX, N91-HOR
  • E9114, E9154, E9174, E91-HDX, E91-RFX, E91-HOR
  • H9114, H9154
  • A9014
  • U9014
  • D9014e


 ATTENTION: It is mandatory to use this version of Toolkit to create USB Recovery Key for ThinOX version 10.2.5 and greater.


For Windows 10 IoT thin client models use this version or newer to restore or clone image firmware (e.g. N9012, A9014, U9014 and D9014).

DO NOT USE USB 3.0 PORT FOR MODEL U9050, U9200, U9080, U9700

Do not use the key generated by the Toolkit on thin client models U9050, U9200, U9080, U9700 on USB 3.0 ports. The USB key generated by the Praim Toolkit is not working using USB 3.0 ports on the thin client models U9050, U9200, U9080, U9700; in this case use only USB 2.0 ports.

NOT Supported Thin Client Models

These old models are NOT supported: INO-840, XP-6600, XP-6700.

Release Notes

Issue IDTypeFromDescription
TCTK-176Improvement1.5.6Added boot image version 1.1.2. It will solve some bug and improve features.
TCTK-175Improvement1.5.6In the case a template is applied through the USB Recovery operation, the parameter "Maintain device Network Settings" allows maintaining the device network settings or to overwrite them with those contained in the template.
TCTK-166Fix1.5.6Windows Embedded 7 device models: only the A9700 is shown.